Bay Networks BayStack 281 Series Manual page 2

© 1996 by Bay Networks, Inc. All rights reserved.
Trademarks
Optivity is a registered trademark of Bay Networks, Inc. Bay Networks, Bay Networks Press,
BayStack, LattisSpan, Optivity LAN, Optivity LANarchitect, System 5000, System 3000, and
PhonePlus are trademarks of Bay Networks, Inc.
Other brand and product names are registered trademarks or trademarks of their respective holders.
Statement of Conditions
In the interest of improving internal design, operational function, and/or reliability, Bay Networks,
Inc. reserves the right to make changes to the products described in this document without notice.
Bay Networks, Inc. does not assume any liability that may occur due to the use or application of the
product(s) or circuit layout(s) described herein.
Federal Communications Commission (FCC) Statement
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not
installed and used in accordance with the instruction manual, it may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference, in which case users will be required to take whatever measures may be necessary to
correct the interference at their own expense.
EN 55 022 Declaration of Conformance
This is to certify that the Bay Networks BayStack 281xx Fast Ethernet Switch is shielded against
the generation of radio interference in accordance with the application of Council Directive
89/336/EEC, Article 4a. Conformity is declared by the application of EN 55 022:1987 Class B
(CISPR 22:1985/BS 6527:1988).
Compliance with the Class B regulations is dependent upon the use of shielded cables. The user is
responsible for procuring the appropriate cables.
Voluntary Control Council for Interference (VCCI) Statement
This equipment is in the 1st category (information equipment to be used in commercial and/or
industrial areas) and conforms to the standards set by the Voluntary Control Council for
Interference by Data Processing Equipment and Electronic Office Machines that are aimed at
preventing radio interference in commercial and/or industrial areas.
Consequently, when this equipment is used in a residential area or in an adjacent area thereto, radio
interference may be caused to equipment such as radios and TV receivers.
Compliance with the VCCI regulation is dependent upon the use of shielded AC power cables.
The user is responsible for procuring the appropriate cables. Read instructions for correct handling.
ii 893-00965-A