Programming No Read Error Messages; Good Read Led Operation - Opticon NFT 2100 User Manual

Manual No. 25-ULNFT2100-01; Mar, 2005
Scanner
33. No read error messages.
The scanner can be programmed to transmit an error message when no barcode is read. The unit must
be in trigger mode, then, the error message will be sent at the end of a trigger time out. 2 types of
messages can be sent. The first type will indicate that no label was present or that nothing was in front
of the scanner. The second type will indicated that a barcode was present but could not be decoded.
To program an error message, scan the appropriate command below then scan up to 4 direct input
characters. To remove the error message, scan the appropriate command below but do not scan any
direct input characters.

33. Programming No read Error Messages

Computer
Command
(ZZ)
TH
TI

34. Good Read LED Operation

Computer
Command
(ZZ)
T4
T5
T6
T7
Function
/Description
START/END
Programming Menu
Program Error message for No
label present.
Program Error message for label
present but not decodable.
Function
/Description
START/END
Programming Menu
Good read LED
disabled after decode
Good read LED ON after
decode for .20 seconds
Good read LED ON after
decode for .40 seconds
Good read LED ON after
decode for .80 seconds
NFT 2100 CCD Fixed Mount Barcode
Bar Code
Command
[[
UI
UJ
Bar Code
Command
[[
U5
U6
U7
U8
Page 63