Replacing The Diaphragm Of The Expiratory Valve - Dräger Savina 300 Technical Documentation Manual

Replacing the diaphragm of the expiratory valve

Introduction
View
Removal
The following section provides a view of the expiratory valve diaphragm and
describes how to remove and fit it.
The diaphragm (Fig. 40/1) is located on the expiratory valve.
Fig. 40 Detail view of expiratory valve; diaphragm
1. Push the flow sensor flap
2. Push the flow sensor
3. Turn the locking ring
B as far as it will go.
Fig. 41 Detail view of Savina 300; removing the expiratory valve
Savina 300

Replacing the diaphragm of the expiratory valve

(Fig. 41/1) up to position A.
(Fig. 41/2) to the left as far as it will go.
(Fig. 41/3) of the expiratory valve to the left towards
Maintenance instructions
47