Dust-Hood; Pedestal Switch; V-Belt - Craftex CT201 Owner's Manual

Installing the Dust Hood
Attach the dust hood to the side on the
stand assembly by using the he
fl at washers and hex nuts provided. (See
Figure 9)
Figure 9: Installing dust hood
This machine produces large amount
of dust. To avoid respiratory illness do
not run it without the dust collection
system
In stalling the Pedestal Switch
T o install the pedestal switch, take the
s witch and attach it to the stand using the
s crew lock washers, flat washers and
cap screws. There is a wire that comes
from the motor to the switch. You can
p ass the excess motor wire to the stand
th rough the hole located in the stand.
(S ee figure 10)
ASSEMBLY
x bolts,
Figure 10: Installing pedestal switch
Installing the V-Belt
Your machine is provided with a V-belt
that goes around the motor pulley and
the cutterhead pulley.
T o install the V-belt loosen the motor
b acket fasteners and slide the motor r
li t tle upward. Now, put the V-belt aroun
th e motor pulley taking it around the
cutterhead pulley. Then slide back the
motor downward and tighten the motor
bracket fasteners. (See Figure 11)
Make sure that both the pulleys are
aligned and the V-belt goes straight up
and down.
Figure 11: Installing V-belt
a
d
13