Power Supply - Craftex CX Series User Manual

POWER SUPPLY

AVAILABILITY OF POWER
Before Installation of this machine you
will need to consider the proximity of
your power supply circuit. If available
circuits do not meet the requirements for
this machine you will have to get a new
circuit installed by a licensed electrician.
Use of a licensed electrician
minimize the risks of fire, electrocution,
damage to equipment, and will insure
everything is wired in accordance to the
applicable codes and standards.
FULL LOAD CURRENT RATING
This is the amount of Amps a machine
draws under 100% of the rated output
power.
FULL LOAD RATING FOR 120V
15AMPS
The full load current is not the maximum
amount of amps the machine will draw.
The machine has potential to draw
current beyond the full load rating if it is
overloaded. Overloading of the machine
for an extended period of time can
cause damage, overheating, or even
fire. The risk is higher if the machine is
on an undersized circuit. To help avoid
these issues insure you are connected
to a circuit that meets the specified
circuit requirements for this piece of
machinery.
Do not connect machine to power
before
completed to avoid risk of personal
will
injury or property damage.
CIRCUIT REQUIREMENTS FOR
CX06HC JOINTERS
The CX06HC has been prewired at the
factory for operation on an electrical
circuit that has a verified ground and
meets the below requirements:
Voltage:
Cycle:
Phase:
Circuit Breaker Size:
Please Note:
1. An electrical circuit includes all
electrical equipment between the
breaker panel and the machine. This
is why it is important to have the
proper circuit size so it can safely
accommodate this machine under
full load for an extended period of
time.
2. The circuit requirements laid out in
this manual are for a dedicated
circuit in which only one machine will
be operational or installed at a time.
6
WARNING!!!
setup has been
110V – 120V
fully
60Hertz
Single
20Amps