Menu List; System Config Menu - Sony HDCU5000 Operating Instructions Manual

Menu List

Legend
The following conventions are used in the menu list table.
Settings column values (e.g. ON, OFF, 0): Default settings are underlined
Execute using ENTER: When using the setup menu directly, press the CONTROL knob or move the CANCEL/ENTER lever to
the ENTER position to execute. When using the web menu, click the ENTER button in the OSD menu to execute.

SYSTEM CONFIG Menu

SYSTEM CONFIG
Page name Item
Page No.
<CAMERA I/F> CABLE TYPE
S01
FIBER TRANSMIT
RATE
OPTICAL SIGNAL
BARS
TEST
START UP VIDEO
SIGNAL
<VIDEO I/O> SDI-I/O 1
S02
SDI-I/O 2
SDI-I/O 3
Set value
FIBER CAMERA CABLE, COAX,
COAX(HDCE), SINGLE-MODE
FIBER
HIGH, ULTRA, ---
ON, OFF
OFF, ON
OFF, TEST1, TEST2
BARS, GRAY
I/O IN, OUT
SIGNAL When OUT is selected in I/O:
SDI-OUT
When IN is selected in I/O:
SDI-RET
I/O IN, OUT
SIGNAL When OUT is selected in I/O:
SDI-OUT
When IN is selected in I/O:
SDI-RET
I/O IN, OUT
SIGNAL When OUT is selected in I/O:
SDI-OUT, HD TRUNK
When IN is selected in I/O:
SDI-RET
Description
Specifies the cable type used for connecting the
camera.
SINGLE-MODE FIBER: Selectable only when the
HKCU-SM50 is installed.
Sets the transfer rate when an optical fiber cable is
connected.
HIGH: When the HDC3500 (without HKC-FB50
installed), HDC3100, or HDC2000 series is
connected
ULTRA: When the HDC5000/5500 or HDC3500
(with HKC-FB50 installed) is connected
---: When CABLE TYPE is set to COAX or
COAX(HDCE)
Turns the optical signal output from the CCU to the
camera ON/OFF.
(Displayed only when connected using optical fiber
composite cable.)
Turns color bars ON/OFF.
Turns TEST SAW ON/OFF.
Selects the signal to output until the unit connects
with the camera after power-on.
Sets SDI I/O 1.
Selects input or output.
Sets the signal function.
Sets SDI I/O 2.
Selects input or output.
Sets the signal function.
Sets SDI I/O 3.
Selects input or output.
Sets the signal function.
30