Maintenance Menu - Sony HDCU5000 Operating Instructions Manual

MAINTENANCE Menu

MAINTENANCE
Page name Item
Page No.
<TRUNK/PROMPTER> TRUNK LINE
M01
PROMPTER CH
<TRUNK/PROMPTER2> NETWORK TRUNK
M02
HD/UHD TRUNK
HD PROMPTER
UHD PROMPTER
Set value
CHANNEL MODE 2CH(MAX 75Kbps),
1CH(MAX 150Kbps)
INTERFACE 232C, 422A
2CH, 1CH
OFF, NETWORK,
NETWORK+VIDEO
DATA RATE 100Mbps, 1Gbps
CAMERA ENABLE, DISABLE
ENABLE, DISABLE
DATA RATE 1.5G, 12G
ENABLE, DISABLE
FRAME SYNC OFF, ON, (ON)
SOURCE SDI-I/O4, IP-RET3
ENABLE, DISABLE
DATA RATE 1.5G, 3G, 6G, 12G
FRAME SYNC OFF, ON, (ON)
SOURCE UHD-SDI D
Description
Sets the number of channels to be used.
Sets the communication line mode.
Sets the number of prompter lines.
Note
The number of lines will vary depending on the
number of prompter lines of the connected camera.
Sets the mode for the network trunk.
OFF: NETWORK TRUNK is not used.
NETWORK: Network Trunk is used (maximum
1 Gbps)
NETWORK+VIDEO: Network trunk is used at the
same time as HD Trunk/HD Prompter (maximum
100 Mbps)
Note
When <CAMERA I/F> t FIBER TRANSMIT RATE
is set to ULTRA, this is set to NETWORK+VIDEO
(fixed).
Displays the data transfer rate.
Note
When <CAMERA I/F> t FIBER TRANSMIT RATE
is set to ULTRA, this item can be set.
Displays whether the camera is enabled/disabled
(Display only).
Displays whether HD TRUNK is enabled/disabled
(Display only).
Displays the HD TRUNK data rate.
Displays whether HD PROMPTER is enabled/
disabled (Display only).
Fixed to DISABLE when using SDI-RET on
HDCU5000/5500.
Turns the frame synchronizer function ON/OFF.
Sets the HD prompter signal source.
IP-RET3 can be selected only when the
HKCU-SFP50 ST 2110 Interface Kit is installed.
Displays whether UHD prompter is enabled/disabled
(Display only).
Sets the UHD prompter data rate.
Turns the frame synchronizer function ON/OFF.
Sets the UHD prompter signal source.
72