Sony HDCU5000 Operating Instructions Manual page 76

NETWORK
Page name Item
Page No.
<WEB MENU> WEB MENU
N03
PORT
SERVICE
DISCOVERY
<NETWORK GENLOCK> PORT
N04
NETWORK
GENLOCK
Displayed only when
HKCU-SFP50 is installed.
PROFILE
PTP MASTER INFO
LOCK STATUS
Set value
ENABLE, DISABLE
LAN-COM
ON, OFF
LAN1, LAN2
DISABLE, ENABLE
ST2059-2
DOMAIN 0 to 127, 127
NUMBER
COMMUNICATION MULTICAST MODE, MIXED
MODE MODE
DELAY –7 to –1, –3
REQUEST
INTERVAL
IP ADDRESS 0.0.0.0 to 255.255.255.255
SYNC INTERVAL –7 to –1, –3
PRIORITY 1 0 to 255, 128
PRIORITY 2 0 to 255, 128
STEP ONE-STEP, TWO-STEP
NOT IN USE, NO MASTER,
LOCKING, LOCKED
Description
Enables/disables the web menu.
Selects the connection port.
Enables/disables the service discovery function.
ON: Display the CCU list in the web menu.
OFF: Do not display the CCU list in the web menu.
Notes
• Set this to OFF if the CCU list is not required or
when you want to reduce the network load as
much as possible.
• When set to OFF, the unit cannot be detected by
the service discovery from other CCUs on the
same subnet.
Selects the port to use.
Enables/disables network genlock.
Displays the supported profile.
Only the ST2059-2 profile is supported.
Sets the domain number.
Note
Set to the domain number of the master device to be
connected.
MIXED MODE: Unicast reply to the master.
MULTICAST MODE: Multicast reply to the master.
Displays the delay of the response to the PTP
master.
Displays information obtained from the PTP master.
Displays the IP address of the currently
synchronized PTP master device.
Displays the Sync Interval setting of the master
device.
Displays the priority level of the PTP master.
The lower the number, the higher the priority.
Displays the mode in which the timestamp is sent.
ONE-STEP: Sent in Sync message.
TWO-STEP: Sent in Follow-up message.
Displays the genlock operation status.
NOT IN USE: PTP operation stopped
NO MASTER: PTP master not found
LOCKING: Synchronizing
LOCKED: Synchronized
76