Sony HDCU5000 Operating Instructions Manual page 32

SYSTEM CONFIG
Page name Item
Page No.
<REAR I/F> CHARACTER
S03
PROMPTER2/
VBS-RET
MIC/WF REMOTE
REAR PREVIEW
<GENLOCK> REFERENCE
S04
LOCK STATUS
GENLOCK MODE
H-PHASE STEP
H-PHASE COARSE
V-PHASE
SYNC OUT SELECT
Set value
CHARACTER, AES/EBU, SYNC
ENABLE
MIC REMOTE, WF REMOTE
MOMENTARY, TOGGLE
NOT DETECTED, EXT IN,
1080/59.94I, 1080/23.98PsF,
720/59.94P, 1080/50I,
1080/24PsF, 720/50P
When HD or SD is selected in
GENLOCK MODE:
LOCKED, NOT LOCKED
HD, SD, NETWORK
10F BB OFF, ON
When HD is selected in GENLOCK
MODE:
–3.01 to 3.45 µsec 0.00
When SD is selected in GENLOCK
MODE:
–8.29 to 9.48 µsec 0.00
–99 to 99, 0
0 to 7
SD SYNC, HD SYNC
Description
Sets the function to assign to the CHARACTER,
AES/EBU, SYNC connector.
CHARACTER: Set to VBS output on which
character superposition is performed.
AES/EBU: Set to AES/EBU output.
Note
AES/EBU is available on the HDCU5500/3500 only.
SYNC: Set to SD composite sync or HD tri-level
reference sync signal output from the internal sync
signal generator.
Sets the function to assign to the PROMPTER2/
VBS-RET connector.
Note
Set to ENABLE (fixed).
ENABLE: Set to both signal input for the second
tele-prompter and VBS return signal input.
Switches the function of pins 36 to 43 when a D-Sub
50-pin board is mounted as the INTERCOM/TALLY/
IO PORT connector.
Sets the operation mode of the REAR PREVIEW
connector output.
Signal input of the REFERENCE IN connector
(Display only).
Lock status of the external reference signal (Display
only).
Sets the lock mode of the external reference signal.
Notes
• NETWORK is displayed only when the
HKCU-SFP50 ST 2110 Interface Kit is installed.
• Set to NETWORK if operating within an SMPTE
ST 2110 compliant system.
• When set to NETWORK, an external reference
input on the REFERENCE IN connector is not
required, and network synchronization operates
using the LAN 1 and LAN 2 connectors of the
HKCU-SFP50. The network synchronization
setting is configured on the <NETWORK
GENLOCK> page of the NETWORK menu.
Sets whether to use the 10-field ID added to the
external reference signal
This can be selected when GENLOCK MODE is SD
and <MULTI FORMAT> page t SYSTEM is
1.001(525).
Adjusts the horizontal lock phase in relation to the
reference signal (steps)
Adjusts the horizontal lock phase in relation to the
reference signal (fine adjustment)
Adjusts the vertical lock phase in relation to the
reference signal (line)
Sets the output signal of the REFERENCE OUT
connector.
32