Hdcu5000 Rear Panel - Sony HDCU5000 Operating Instructions Manual

o INTERCOM audio input/output and control block
MIC/PGM (microphone/program) switch
PRIV indicator
INTERCOM (intercom select) switch
• INTERCOM (intercom adjustment) knob
Adjusts the headset audio level.
• MIC/PGM (microphone/program) switch
ON: Turns the headset microphone on.
OFF: Turns the headset microphone off.
PGM: Selects program audio output.
• INTERCOM (intercom select) switch
Selects the intercom signal input/output connection source for
the INTERCOM connector on the front panel.
PROD: Connects the producer line.

HDCU5000 Rear Panel

a Option kit mounting port
The HKCU-SFP50 ST 2110 Interface Kit (option) can be
installed.
For an overview of option kits, see "Option Kits" (page 15).
b CAMERA FIBER connector for HDC3500/3100 and
HDC2000 series
Used to connect a video camera, using an optical fiber cable.
All video camera signals, including power supply, control,
video, and audio, are sent and received over one optical fiber
cable.
Note
Dust on the connection surface of the optical fiber cable may
result in transmission errors. When not connected, always
cover the end of the connector with the supplied cap.
INTERCOM connector
INTERCOM (intercom
adjustment) knob
PRIV: Blocks the connection to the producer line or engineer
line, allowing private intercom talk between the CCU and
the camera.
ENG: Connects the engineer line.
• PRIV (private) indicator
Lights when the intercom is in private mode.
• INTERCOM connector (XLR 5-pin)
Connect the intercom headset.
p Call button
When pressed, this outputs a call signal to the camera or
external control devices (the RCP-3000/1000 series Remote
Control Panel, etc.) that are connected to this unit. Use this
when you want to call and speak with the camera operator or
external control device operator via intercom. This button
lights in red when it is pressed or the call button of other
equipment is pressed.
q USB port
Used to connect to a USB device.
r Assignable button
You can set a function for this button via the CCU menu.
c Option kit mounting port
Used to install HKCU-SDI50 12G-SDI Extension Kit.
For an overview of option kits, see "Option Kits" (page 15).
d NETWORK TRUNK connector (RJ-45 8-pin)
Used to connect the device connected to the NETWORK
TRUNK connector of a camera with the network connection
device.
e LAN COM connector (RJ-45 8-pin)
Used to connect to a LAN. Connect a LAN hub (10BASE-T/
100BASE-TX/1000BASE-T), using a LAN cable (shielded
type of category 5 or higher).
11