Option Kits - Sony HDCU5000 Operating Instructions Manual

q INTERCOM/TALLY/IO (intercom / tally / input/output)
connector (D-sub 50-pin)
Used to input and output intercom, tally, and program audio
signals. Connect to the intercom/tally/program audio
connector of the intercom system.
REAR PREVIEW function: Pin 35 is assigned for the output
pin of the REAR PREVIEW function.
r - AC IN (AC power input) connector
Use the specified AC power cord to connect to an AC power
supply. The AC power cord can be secured to this unit using
the plug holder (optional).

Option Kits

Note
For safety, only a qualified technician with service training
should perform tasks inside the unit.
For details about installation, contact a Sony service or sales
representative.
HKCU-FB50 UHB Transmission Board Kit
This unit is an option kit that replaces the q; UHD SDI A/B/C/
D connectors on the rear of the HDCU3500 and enables 4K
transfer on the HDCU3500.
Note
HZCU-UHD35 4K/HDR Processor Software (option) is
required for 4K output.
HKCU-SDI50 12G-SDI Extension Kit
This unit is an option kit that can be installed in the option kit
mounting port 3 on the rear of the HDCU5000 Camera
Control Unit and enables support for 1-system quad 12G-SDI
output at 4K.
HKCU-SFP50 ST 2110 Interface Kit
This unit is an option kit that can be installed in the option kit
mounting port 1 on the rear of the HDCU5000/5500/3500
Camera Control Unit and enables connection with SMPTE ST
2110 compliant devices.
For HDCU5000
For HDCU5500/3500
IP video signals and audio input/output, intercom, and network
synchronization are performed using the LAN 1 and LAN 2
connectors (SFP+/SFP28). This enables one 4K and three HD
IP inputs/outputs on the HDCU5000/5500/3500.
For RCP/MSU device connection and IP tally input, use the
LAN COM connector.
The input/output signal format is set using <OUTPUT
FORMAT IP> and <RETURN FORMAT IP> in the setup menu
of the HDCU5000/5500/3500.
Note
An OTM-10GSR1 or other SFP+ module or SFP28 module is
required to use IP output.
HKCU-SM50 Single Mode Fiber Connector Kit
This unit is an option kit that can be installed in the option kit
mounting port qg on the rear of the HDCU5000 Camera
Control Unit or qs on the rear of the HDCU5500/3500 Camera
Control Unit, and enables single mode fiber transfer on the
HDCU5000/5500/3500.
Note
It can only be used to connect with HDC3500/3100 and
HDC2000-series cameras. It cannot be connected with the
HDC5000/5500.
For HDCU5000
15