Option Kits - Sony HDCU3100 Operating Instructions Manual

Option Kits

Note
For safety, only a qualified technician with service training
should perform tasks inside the unit.
For details about installation, contact a Sony service or sales
representative.
HKCU-FB30 Optical Fiber Connector Kit
This unit is an option kit that can be installed in the option kit
mounting port l on the rear of the HDCU3170 and supports
optical fiber transmission.
When a video camera is connected using an optical fiber
cable, all video camera signals, including power supply,
control, video, and audio, are sent and received over one
optical fiber cable.
HKCU-SFP30 ST-2110 Interface Kit
This unit is an option kit that can be installed in the option kit
mounting port c on the rear of the HDCU3100/HDCU3170
Camera Control Unit and enables connection with SMPTE ST
2110 compliant devices.
IP video signals and audio input/output, intercom, and network
synchronization are performed using the LAN-1 and LAN-2
connectors (SFP+/SFP28). This enables three IP outputs and
three IP inputs for HD signals on the HDCU3100/HDCU3170.
For RCP/MSU device connection and IP tally input, use the
LAN-COM connector.
The input/output signal format is set using <OUTPUT
FORMAT3> and <RETURN FORMAT3> in the setup menu of
the HDCU3100/HDCU3170.
Notes
• HDCU3100/HDCU3170 software version 1.10 or later is
required.
• An OTM-10GSR1 or other SFP+ module or SFP28 module
is required to use IP output.
HKCU-SM30 Single Mode Fiber Connector Kit
This unit is an option kit that can be installed in the option kit
mounting port k on the rear of the HDCU3100 Camera
Control Unit or in the option kit mounting port c on the rear of
the HDCU3170, and supports single mode fiber transmission.
HDCU3100
HDCU3170
The CAMERA SMF IN connector inputs the video signal from
the camera, audio (microphone) signal, HD-TRUNK signal,
and NETWORK TRUNK signal.
The CAMERA SMF OUT connector outputs the return video
signal to the camera, prompter video signal, program audio
signal, and NETWORK TRUNK signal. The RS-422A and RS-
232C interfaces are also supported.
Notes
• HDCU3100/HDCU3170 software version 2.00 or later is
required.
• Dust on the connection surface of the connector may result
in transmission errors. When not connected, always cover
the end of the connector with a cap.
12