Pressure Hose - Raven SmarTrax Supplement Installation Manual

In this picture, the ports are labeled:
EF - Pressure In (from EF port on the SmarTrax valve)
R - Right Steer Port
T - Tank Port
L - Left Steer Port

Pressure Hose

1. Remove the existing pump to orbital hose and attach it to the 'P' port
on the SmarTrax valve. It may be necessary to use the supplied 90
degree 3/4" JIC elbow fittings to ensure the hoses are routed properly.
Excess Flow Hose
1. Connect one end of the excess flow hose (P/N 214-1000-250) to the
fitting EF Port on the SmarTrax Valve.
2. Connect the remaining open end of the excess flow hose to the pressure
port on the steering orbital.
Tank Port Hose
1. Remove the existing tank to orbital hose at the orbital and attach a
supplied 3/4" tee fitting to the orbital.
2. Reconnect the hose to the tee fitting.
3. Attach a tee fitting to the 'T' Port on the SmarTrax valve.
4. Connect one end of the tank hose (P/N 214-1000-428) to this tee and
the other end to the remaining open port of the tee on the orbital.
Needle Valve Hose
1. Attach the hose (P/N 214-1000-429) to the needle valve, which is
attached to the counterbalance valve.
Manual # 016-0190-072
9