Mount The Was - Raven SmarTrax Installation Manual

Chapter 4

Mount the WAS

Turn the machine's front wheels to the right to access the left front axle area.
1.
Steering Cylinder Bolt
FIGURE 2.
Remove the bolt on the bottom-right corner of the left steering cylinder cap.
2.
Base-End of Sensor Installed on the Machine
FIGURE 3.
Align the base WAS mounting bracket (P/N 107-0172-077) over the hole, rotating it as shown in Figure 3
3.
above.
Replace the cylinder bolt.
4.
Secure the base-end of the WAS (P/N 063-0181-017) to the bottom of the base mounting bracket using one
5.
M10 x 1.5" nylon insert lock nut (P/N 312-4000-208) and one washer (P/N 313-2300-014).
18 Valtra BT150, BT170, BT190, and BT210 SmarTrax Installation Manual