Raven SmarTrax Installation Manual page 23

Rod-End Mounting Bracket
FIGURE 4.
Remove the nuts and clamp from the 1-3/8" muffler clamp (P/N 435-3003-054) and install the U-bolt around
6.
the left tie-rod with the U-bolt ends facing up.
Install the clamp on the ends of the U-bolt.
7.
Install the WAS rod mounting bracket (P/N 107-0172-076) over the ends of the U-bolt and secure it using
8.
two 5/16" nylon insert thin lock nuts (P/N 312-4001-107) as shown in Figure 4 above.
Rod-End of Sensor Mounted to the Machine
FIGURE 5.
Mount the rod-end of the WAS to the rod mounting bracket using two washers (P/N 313-2300-014) and one
9.
M10 x 1.5 nylon insert lock nut (P/N 312-4000-208).
Important:
Verify that the WAS cannot be overextended or compressed when the wheels are turned to their
extremes. Also verify that the sensor moves freely and is not being damaged within its range of motion.
Route the cable from the base-end of the WAS along the tractor frame so that it is not near moving parts or
10.
heat sources. Secure with plastic cable ties as necessary.
Manual No. 016-5033-101
Wheel Angle Sensor Installation
19