Raven SmarTrax Installation Manual page 28

Chapter 5
Valve Harness Routed into the Cab
FIGURE 5.
Hole Bored into
Cab Floor
Route the 12-pin connector of the valve harness (P/N 115-4001-096) into the cab.
1.
Connect the 12-pin connector of the valve harness into the mating connector of the node harness (P/N 115-
2.
4001-109).
VALVE Harness Connection
FIGURE 6.
Connect the VALVE connector to the open 4-pin port of the SmarTrax valve (P/N 334-0003-088).
3.
Connect the TRANSDUCER connector to the pressure transducer (P/N 422-0000-086) installed in Port PS
4.
of the SmarTrax valve.
Route and connect the WAS connector to the cable of the installed WAS (P/N 063-0181-017).
5.
Note:
Secure cable with plastic cable ties.
24 Valtra BT150, BT170, BT190, and BT210 SmarTrax Installation Manual
Valve Harness
Connected to
Node Harness