Wheel Angle Sensor Installation; Assemble The Wheel Angle Sensor (Was) - Raven SmarTrax Installation Manual

CHAPTER
4

Assemble the Wheel Angle Sensor (WAS)

WAS Assembly
FIGURE 1.
Install one M10 stud linear sensor mount (P/N 103-0001-030) and one M10 jam nut (P/N 312-1001-035) on
1.
the base-end (where the cable connects) of the 250 mm non-contact linear wheel angle sensor (WAS) (P/N
063-0181-017).
Install the other M10 stud linear sensor mount and M10 jam nut on the rod-end of the WAS.
2.
Manual No. 016-5033-101
W heel Angle Sensor
C h a p t e r 4
Installation
17