Jack Storage - BALZER FIELD FLOATER 6 User Manual

PTO Drive System
The PTO shaft will have the 1 3/4" 20 Spline connection on both ends The implement side has a cam clutch to protect the gear
box and drive line of the tractor's PTO from overload (Figure 8) The PTO must be engaged slowly, use maximum modulation
on the tractor DO NOT SLAM ENGAGE THE PTO.
The PTO shaft should not be extended any more than half the length of the telescoping member overlap
WARNING
DANGER

Jack Storage

After the machine has been securely attached to the drawbar of the tractor and the jack is no longer supporting the weight of
the tongue, finish raising the leg of the jack Remove the two locking pins (Figure 9), move the jack to the storage location on
the tongue, and re-insert the locking pins to secure the jack (Figure 10)
WARNING
WARNING
18
FIGURE 8
Cam Clutch
DO NOT slam engage the PTO. Damage to the machine
or the tractor may occur at any time during operation
following a slam engagement of the PTO.
DO NOT OPERATE this machine without all PTO shields
and guards in place and properly secured.
DO NOT move or operate this machine with the jack
in the support position. Failure to move the jack to
the storage position may result in damage to the jack
and/or this machine.
DO NOT use the jack in the support position unless
the grain cart is empty.
Field Floater 6 Grain Cart User Manual
OPERATION