BALZER FIELD FLOATER 6 User Manual page 24

Tie rod
Suspension Hydraulics (Continued)
On each side, the base end of the cylinders are hydraulically connected to each other The base end of the left side suspension
cylinders DO NOT connect to the base end of the right side suspension cylinders Once each circuit is charged, the circuit
is closed With the left side cylinders connected to each other and the right side cylinders connected to each other (Figure
16), the hydraulic fluid can flow from one cylinder base to the other on the same side This allows for the load to equalize and
permit the axles to move up or down to negotiate ground variations and field approaches The fast hydraulic fluid flow between
cylinders assures each tire carries the same load as the next without spikes
The rod ends of all suspension cylinders are connected to a low pressure source to keep them full for seal lubrication Once
filled, the valve is closed (Figure 17) The middle suspension cylinders are not used with a tandem frame
20
FIGURE 11
Tie rod grease point
(two on each tie rod)
Tractor steering
connections
FIGURE 13
OPERATION
FIGURE 12
Field Floater 6 Grain Cart User Manual