Table of Contents
Advertisement
MAINTENANCE
Daily and Before Start of Season (Continued)
6
Inspect all moving components for damage or excessive wear Repair or replace as needed
7
Check braking system for damage or excessive wear Repair or replace as needed
8
Check for solid, hard, or frozen substances on all moving parts Remove substance to avoid damaging the machine
9
Grease all points shown in Figure 47 Grease steering system according to "Steering System Lubrication" on Page 39
Grease the horizontal auger
bearing on the back of the grain
cart
Apply grease to both grease
points on each tie rod The
kingpins have poly bushings
and do not need grease
After Starting Tractor
10 Check braking system for proper working operation
11 Recheck all hydraulic hoses and connections for leaks
12 Check all lights for proper operation Replace as needed
13 Grease according operational requirements stated on the machine
WARNING
Field Floater 6 Grain Cart User Manual
FIGURE 47
Apply grease to the vertical auger
cylinder base and to all points on
the grease bank, if present, located
on top of the auger gear box
Hydraulic and brake lines are under high pressure
when tractor is running. Hydraulic fluids can become
hot enough to cause serious burns. Use proper safety
equipment when checking lines.
Grease points on both crosses
of the PTO shaft and on the
shaft itself
Grease points on both sides of
Bull Pull hitch
37
Advertisement
Table of Contents
