Table of Contents
Advertisement
MAINTENANCE
Steering Axle Toe Adjustment (Continued)
8
The inside front measurement should be 1/16" (1 6 mm) shorter than the inside rear measurement
9
If adjustment is needed, loosen both jamb nuts on the tie rod (Figure 57) Rotate the direction needed to set the proper
toe (Figure 58) Do not tighten the jamb nuts yet
10 Measure both rims again for proper toe setting and readjust as necessary
11 Tighten both jamb nuts on the tie rod and tighten the steering hydraulic cylinder's clevis clamp nut and bolt
Brake System
Adding Brake Fluid
1
Attach the jumper hose (Part #: 72182) between "A" port and "B" port (Figure 59 and Figure 60)
2
Connect the 1/4" hydraulic brake hoses (Red) to the tractor
3
Open ball valve on jumper hose (Figure 61)
4
Apply and hold pressure to braking system from tractor hydraulics
5
Relieve all pressure from the 1/4" hydraulic brake hoses (Hoses with Red stripes)
6
Close ball valve on jumper hose (Figure 62)
7
Remove jumper hose from "A" port and "B" port
8
Apply and hold pressure to braking system
9
Open bleeder screw on any brake caliper to adjust the brake master cylinder (Figure 63)
10 Allow the pressure releasing spring on the brake master cylinder to compress to 14" (35 6 cm) (Figure 64)
FIGURE 59
FIGURE 61
To open the ball valve on the Bleeder Hose, rotate the handle so
that it is inline with the hose
Field Floater 6 Grain Cart User Manual
"A" Port
"B" Port
FIGURE 60
FIGURE 62
To close the ball valve on the Bleeder Hose, rotate the handle
so that it is perpendicular with the hose
"A" Port
Jumper Hose (72182)
"B" Port
43
Advertisement
Table of Contents
