Front Panel Controls - BALZER FIELD FLOATER 6 User Manual

Table of Contents

Grain Cart Weigh System Operation

Front Panel Controls

The front panel controls operate the same for both the scale indicator and the host indicator When the two units are connected,

some changes made on one unit will make the same changes on the other unit For example, if you wanted to display the

weight in kilograms instead of pounds, you will only need to make the change on one unit When the desired change is saved,

it will make the same change on the other unit

Figure 33 shows the front panel layout

The

turns the indicator on or off If the scale

The

will zero only the gross weight To zero the scale, press and hold for two seconds If this is done while there is some

grain in the cart, when that grain is unloaded, the scale will display a negative weight This will zero both indicators

The

has two uses When in a data entry situation (menu selection, memory location, etc ), it will cycle through the

available selections Otherwise it will lock the displayed weight IF THE HOLD IS ENABLED AND USED TO LOCK THE

WEIGHT, ANY GRAIN ADDED OR REMOVED FROM THE CART WILL NOT HAVE ITS WEIGHT RECORDED This feature

is disabled by default

The

will send the stored data to a display or printer device connected to the RS232 port and will also export the data as

a text ( TXT) file to the USB port when a USB flash drive is inserted Note: When inserting a USB flash drive into the USB port,

make sure the LED next to the port lights green If the LED does not light up, cycle the power on the host indicator

The

will set the displayed weight as the TARE weight and change the display to showing the NET weight This will only

affect the indicator on which the TARE button was pressed To clear a set tare weight, press the

FIGURE 33

OPERATION

and the

Field Floater 6 Grain Cart User Manual

at the

Table of Contents