Pto Drive System; Hydraulic Drive System; Jack Storage - BALZER ELIMINATOR VACUUM TANK Series User Manual

PTO Drive System

If this machine is equipped with a PTO shaft, it will have one of the following shafts (check which shaft is used):
o PTO Shaft, 1 3/8"-21 to 1 1/2" Round with 3/8" Keyway (Standard)
o PTO Shaft, 1 3/4"-20 to 1 1/2" Round with 3/8" Keyway
o PTO Shaft, CV 1 3/8"-21 to 1 1/2" Round with 3/8" Keyway
o PTO Shaft, CV 1 3/4"-20 to 1 1/2" Round with 3/8" Keyway
The PTO shaft will have the 1 1/2" Round with 3/8" Keyway attached to the implement side of the machine . This implement
side has a shear bolt to protect the gear box and drive line of the tractor's PTO from overload (Figure 10) . The PTO must be
engaged slowly, use maximum modulation on the tractor . DO NOT SLAM ENGAGE THE PTO.
1 1/2" Round with 3/8" Keyway
WARNING
DANGER
The PTO shaft should not be extended any more than half the length of the telescoping member overlap .

Hydraulic Drive System

If this machine is equipped with a hydraulic motor, it will have one of the following (check which motor is used):
o 3 .94 CU IN Hydraulic Motor (Standard)
o 6 .35 CU IN Hydraulic Motor
When engaging the hydraulic motor, do so slowly to avoid damage to the motor .

Jack Storage

After the machine has been securely attached to the drawbar of the tractor and the jack is no longer supporting the weight of
the tongue, finish raising the leg of the jack . Remove the two locking pins (Figure 11), move the jack to the storage location on
the tongue, and re-insert the locking pins to secure the jack (Figure 12) .
18
Figure 10
Shear Bolt
DO NOT slam engage the PTO. Damage to the machine
or the tractor may occur at any time during operation
following a slam engagement of the PTO.
DO NOT OPERATE this machine without all PTO shields
and guards in place and properly secured.
OPERATION
Eliminator Vacuum Tank (Tandem) User Manual