BALZER FIELD FLOATER 6 User Manual page 71

WEIGH SYSTEM PROGRAMMING
Host Indicator Programming (Continued)
Set RS232 Port Baud Rate
The following steps will set the output data rate of the RS232 serial port to match that of an external display/reporting device
Step
Set Baud Rate
Select Baud Rate
Accept your selection
Calibration Menu System
The following options are accessible through the calibration menu system:
Display
Calibration Step Code Default is 000 This continues through the main calibration menu There
Field Floater 6 Grain Cart User Manual
Button
Function
are no user serviceable Calibration Sub menus
Read Only Mode This option is for when multiple host indicators are used with the same
scale indicator It is not applicable to this grain cart configuration as it is
delivered
Radio Enable Allows the host indicator to communication wirelessly with other
compatible equipment and devices
Radio Channel Sets the radio channel when the radio is enabled There are 12 radio
channels available
Radio Network ID Sets the radio's network identification (0-65534) for the radio channel
being used
Radio Encryption Turning on the radio encryption makes the transmitted signal unable to be
Enable and Key decoded without the receiver having the same encryption key (encryption
key value range: 0-65534) NOTE: IF YOU FORGET THE ENCRYPTION
KEY VALUE, YOU WILL NOT BE ABLE TO CONNECT A RECEIVING
DEVICE
Restore Radio Default is 0 This leaves the radio settings as they have been programmed
Defaults Entering 3 will restore the radio settings to their default values
Unit Switch Enable Allows the changing of weighing units from pounds (lbs) to kilograms (kg)
through the main menu
Auto Zero Tracking Automatic adjustment to the scale should the zero reading drift from the
set zero of the scale
Graduation Size Set weighing incremental count
Entry Option
The default selection is 9600 - display will be
flashing
Cycle through baud rate selections of 1200,
2400, 4800, 9600, 19200, 38400, 57600, and
115200
Definition
Display
67