Setting Of Operating Parameters - Nakanishi E2280 Operation Manual

18. SETTING OF OPERATING PARAMETERS

18 - 1 Entering Parameter Setting Mode
CAUTION
When in the parameter mode, normal operation of starting, stopping, etc. operation is not possible.
When changing from the parameter mode to normal operation, be sure to toggle the Main Power
Switch ⑨ OFF and ON again.
(1) Make sure that the Main Power Switch ⑨ is turned OFF.
(2) While pushing and holding the Error Reset Button (RESET) ㉑ while turning the Main Power Switch ⑨ ON at
the front of the CONTROLLER.
(3) Hold the Error Reset Button (RESET) ㉑ down for 3 seconds while the CONTROL is powering up.
(4) The buzzer will ' BEEP ' 3 times, then release the Error Reset Button (RESET) ㉑ and Parameter Setting
Mode will start.
18 - 2 Parameter Types
Parameter types, contents, and default are detail in Table. 10.
When checking a parameter or changing a setting, refer to P104 " 18 - 4 Setting procedures " section.
Table. 10
Code Types
Setting of Error Output Mode
Setting AUTO Mode for Motor
Speed Control
Setting Fixed Motor No. 1 Speed
Setting Fixed Motor No. 2 Speed
96
is Displayed.
Contents
Changes the Error Output Signal, when an error occurs
from normally open to normally closed.
When the control is in AUTO mode, the speed
control is adjustable from the Control Panel ② of the
CONTROLLER, set the parameter to
speed in AUTO Mode.
When Fixed Motor Speed is desired, set the parameter
to
* Settable Motor Speed range is 1,000 - 50,000min
1,000min
* When the Motor Rotation Speed set in parameter
parameter
be the rotational speed that was set in the parameter
When Fixed Motor Speed is desired, set the parameter
to
* Settable Motor Speed range is 1,000 - 50,000min
1,000min
* When the Motor Rotation Speed set in parameter
parameter
be the rotational speed that was set in the parameter
.
-1
increments.
is higher than the Motor Rotation Speed set in
, the actual motor rotation speed will
.
.
-1
increments.
is higher than the Motor Rotation Speed set in
, the actual motor rotation speed will
.
Default
to adjust the
-1
in
-1
in