Nakanishi E2280 Operation Manual page 24

③ Set by the Speed Point Signal
(Set parameter
Select the 4 Speed Points set beforehand by combination of " Speed Point Select 0 (POINT 0) (Pin No. 17 :
SEL0) " and " Speed Point Select 1 (POINT 1) (Pin No. 5 : SEL1) ".
When selecting the Speed Point (
(Closed) ".
Table. 4 Combining Speed Point Select 0 (POINT 0) (Pin No. 17 : SEL0) with Speed Point Select 1 (POINT 1)
(Pin No. 5 : SEL1) for Motor No. 1
Speed Point
When selecting the Speed Point (
SEL) " to ' ON (Closed) '.
Table. 5 Combining Speed Point Select 0 (POINT 0) (Pin No. 17 : SEL0) with " Speed Point Select 1 (POINT 1)
(Pin No. 5 : SEL1) " for Motor No. 2
Speed Point
(5) Resetting System after Error Codes
Releasing Error Code by The " Error Release (Pin No. 4 : RESET) ". Switch the signal on " Error Release (Pin
No. 4 : RESET) " of Input / Output Connector A ③ ' OFF (Open) ' → ' ON (Closed) ' → ' OFF (Open) '.
Error Signal will not be released until cause of the error has been removed.
Refer to P94 " 17 - 3 Resetting System after Error Codes " section.
. (Refer to P106 " 18 - 4 ⑦
-
SEL1(Pin No. 5)
OFF (Open)
OFF (Open)
ON (Closed)
ON (Closed)
-
SEL1 (Pin No. 5)
OFF (Open)
OFF (Open)
ON (Closed)
ON (Closed)
Selection of External Speed Control Mode " section.))
), turn the " Motor Select (Pin No. 15 : MT_SEL) " to " OFF
SEL0 (Pin No. 17)
OFF (Open)
ON (Closed)
OFF (Open)
ON (Closed)
) of Motor No. 2, turn the " Motor Select (Pin No. 15 : MT_
SEL0 (Pin No. 17)
OFF (Open)
ON (Closed)
OFF (Open)
ON (Closed)
79