Motor Cord Connection; Air Hose Connection - Nakanishi E2280 Operation Manual

13. MOTOR CORD CONNECTION

CAUTION
・ Before connecting to the Motor Cord Plug, make sure the Main Power Switch ⑨ is turned OFF.
If the Main Power Switch ⑨ is turned ON while connecting the Motor Cord Plug, damage may occur
to the CONTROLLER.
・ Two motor spindles can be connected to this CONTROLLER (Motor Connector No. 1, Motor
Connector No. 2).
When only one Motor Connector is in use, make sure to attach the connector cap for safety.
(1) Ensure the Alignment Pin is located upward (12 o'clock position).
(2) Carefully insert the Alignment Pin into the Alignment Hole and push straight into the Motor Connectors ⑤ and ⑥
on the front of the CONTROLLER.
(3) Tighten the Connector Nut.
Alignment Pin
Fig. 15

14 . AIR HOSE CONNECTION

CAUTION
When not using NAKANISHI Air Line Kit, make sure that the incoming air supply is dry, clean and
properly regulated.
14 - 1 One Motor Spindle is connected to the
CONTROLLER (Fig. 17)
(1) Insert the provided 6mm Air Hose with Filter from the Air
Line Kit AL-C1204 into the Air Input Joint ⑦ on the front of the
CONTROLLER.
(2) Insert one end of the provided
the back of the motor spindle.
(3) Insert the other end of the
Output Joint ⑧ on the front of the CONTROLLER using the
provided Reducer ( 6mm -
Connector Nut
4mm cooling Air Hose into
4mm cooling Air Hose into the Air
4mm Conversion Adaptor).
Alignment Hole
Fig. 16
⑦
Fig. 17
⑧
71