Nakanishi E2280 Operation Manual page 48

Table. 22
Parameter
⑪
Selection of Emergency Stop Function
・The Emergency Stop Function can be enabled or disabled.
・ When " Emergency Stop A (Pin No. 1 : EMG - INA) " and " Emergency Stop B (Pin No. 9 : EMG - INB) " of the
External Input / Output Connector B ④'s input signal are set to ' OFF (Open) ', Safety Relay will activate and
block the Motor Power Line and make an emergency stop.
Normally, " Emergency Stop A (Pin No. 1 : EMG - INA) " and " Emergency Stop B (Pin No. 9 : EMG - INB) " input
signal need to be set to ' ON (Closed) '.
・ Allows the establishment of a safe machine operating system by utilizing auxiliary contacts of Safety Relay
(SAFE-1, SAFE-2).
Table. 23
Parameter
⑫ Selection of Illumination Brightness
Select the brightness of the blue illumination from 4
patterns.
The brightness can be configured separately for the
Illumination on the front side of the CONTROLLER
and the illumination on the bottom side of the
CONTROLLER.
Table. 24
Parameter
Set Contents
Maximum rotation speed : speed command characteristic of 50,000min
The same speed command characteristic as the previous model E2530
CONTROLLER
Set Contents
Emergency Stop Function is deactivated.
Emergency Stop Function is activated.
Illumination Area
Control Panel Face
Bottom of CONTROLLER
Outline of Control Panel
Fig. 36
Brightness
High
Medium
Low
Off
High
Medium
Low
Off
-1
Two guidelines
Fig. 37
103