Power Cord Connection - Nakanishi E2280 Operation Manual

⑩ Main Power Inlet with Power Supply Fuses
Insert the supplied power cord connector. Refer to P68 " 10. POWER CORD CONNECTION " section.
Two fuses (T1.6AL (250V)) have been installed. Make sure the properly rated and type of fuses are used when
replacements are necessary. When replacing fuse, refer to P70 " 11. REPLACING FUSES " section.
⑪ Fixing Power Cord Hook Bar
⑫ Power Cord Hook (Standard Accessories)
Used for attaching the power cord connector to the Main Power Inlet securely.
Refer to P69 " 10 - 2 Power Cord Connector Connection " section.

10. POWER CORD CONNECTION

WARNING
The input power side of supplied CONTROLLER power cord does not have a male connector
(Fig. 7). The CONTROLLER side has a female connector. Make sure the input power supply is
OFF before wiring. If the input power supply is ON, it may cause risk of death or serious injury
by electric shock.
CAUTION
Only use grounded power sources. Using a non-specified Power Cord, the risk of fire by over-heating
of the cord is possible.
68
Fig. 7