Nakanishi E2280 Operation Manual page 22

Button / LED
KEY HOLD LED ( )
Button ㉕
15 - 2 Select Control Mode (MANUAL / AUTO). (Select the Control Button (CTRL) ⑲ of the
Fig. 20.)
(1) Using the Control Button (CTRL) ⑲ , you can switch the operation
mode for starting / stopping the Motor, setting rotation direction, motor
speed and the like.
MANUAL Mode : Controlled by Control Panel ② .
AUTO Mode : Controlled by input signal to Input / Output Connector
A ③ from External Signal Source.
15 - 3 Setting Motor Rotating Direction, Motor Spindle Selection Motor Start / Stop, Motor Speed
15 - 3 - 1 Manual Mode Operation
(1) Setting Motor Rotating Direction
Set Motor Rotating Direction (Set the Rotation Direction Button (DIR) ⑰ of the Fig. 20.)
Push the Rotation Direction Button (DIR) ⑰ .
Select FWD. : Clockwise rotation
Select REV. : Counterclockwise rotation
With the cutting tool facing the operator right hand rotation (FWD.) will be clockwise rotation.
(2) Motor Selection
Select the motor spindle to be controlled. (Motor Spindle Selection (MOTOR) Button ⑱ of the Fig. 20.) If motor
spindle No. 1 was selected, No. 1 LED turns on. If motor spindle No. 2 was selected, No. 2 LED turns on.
(3) Motor Start / Stop (Motor Start / Stop by pushing the START / STOP Button (START / STOP) ⑯ of the Fig. 20.)
The motor spindle will start and the LED will illuminate.
Push START / STOP Button (START / STOP) ⑯ again and the motor spindle will stop and the LED will go out.
Description
A Key Hold Function is equipped to prevent erroneous operation by touching the
control panel.
All button operations will be disabled.
KEY HOLD LED ( )
goes out (not lit)
KEY HOLD LED ( )
lights
All button operations are enabled.
To disable button operations on the Control Panel ②
・ Press and hold the Error Reset Button (RESET)
㉑ for 3 seconds when the KEY HOLD LED
( )㉕ is not lit.
Key Hold is enabled.
All button operations are disabled. If any button is
pressed, a warning beep will be emitted.
To enable button operations on the Control Panel ②
・ Press and hold the Error Reset Button (RESET)
㉑ for 3 seconds when the KEY HOLD LED
) ㉕ is lit.
(
⑬ ⑮ ②
⑳ ⑲ ⑱ ⑰ ⑯
Fig. 20
77