Nakanishi E2280 Operation Manual page 27

Pin Code Function
No.
14 START Rotate
Command
15 MT_SEL Motor Select Input
-1
16 500min Rotates
(rpm) Motor at
" Centering "
speed
17 SEL0 UP / DOWN
Signal for
Setting Motor
Speed (UD_
IN)
Speed Point
Select 0
(POINT 0)
18 COM_2 External
Power Source
for External
Output
19 PULSE Rotating
Pulse
20 WARNING WARNING
21 COIN Speed
Achievement
―
22 Not used
82
Input / Description
Output
Input ' OFF (Open) ' : Stop
' ON (Closed) ' : Start
' OFF (Open) ' :
MOTOR1
' ON (Closed) ' :
MOTOR2
Input ' ON (Closed) ' :
-1
500min (rpm)
Input ―
Input DC0V or DC+24V
Output 1 pulse / rotation
Output OFF (Open) : Normal
Operation
ON (Closed) : Warning
Output OFF (Open) : Set
speed not achieved
ON (Closed) : Set
speed achieved
― ―
Motor Start and Motor Stop Signal
Setting parameter
forward rotation. (Refer to P107 " 18 - 4 ⑧
Selection of External Motor Start Signal
Control Mode " section.)
Select MOTOR No. 1 or MOTOR No. 2.
Set motor rotation speed will be 500min
(rpm). Use the Centering Mode.
Determines speed up or speed down.
Need to set parameter
" 18 - 4 ⑦ Selection of External
Speed Control Mode " section.)
Speed Point Signal can be selected. Speed
Point (When using Motor No. 1, "
" ", and when using Motor No. 2, "
" ") can be selected by POINT 0 and POINT
1 signal combination. Refer to P79 " 15 - 3 - 2 (4)
③ Set by the Speed Point Signal " section.
Need to set parameter
" 18 - 4 ⑦ Selection of External Speed
Control Mode " section.)
Power source to be used for External outputs
Signals.
1 revolution of the motor generates one pulse.
Duty 50%.
Output shows that warning has occurred.
Warning code will be displayed on Control
Panel ② .
Shows that the Motor has achieved more than
90% of the set speed.
*Note : Never use a pin labeled not used.
, can start with
-1
. (Refer to P106
" -
" -
. (Refer to P106