Nakanishi E2280 Operation Manual page 21

Button / LED
Error Reset Button (RESET)
㉑
Error LED (ERROR) ㉒
Warning LED (WARNING)
㉓
Rotating LED (RUN) ㉔
76
Description
This switch resets and allows restarting of the motor spindle after an error has
been corrected.
To reset when an error occurs,
1. Remove or correct the cause of the error.
Check P94 " 17 - 3 Resetting System after Error Codes Table. 9 ".
Error will not be reset until the cause of the error has been removed.
2. Push the Error Reset Button (RESET).
CAUTION
If Error Signal cannot be reset by pushing the Error Reset Button
(RESET) ㉑ , there is a possibility that the CONTROLLER has been
damaged.
Please contact your local dealer.
When a serious problem with the system occurs, an alarm is emitted and this LED
illuminates.
Error LED (ERROR)
goes out (not lit)
Error LED (ERROR)
lights
The operating and working conditions of the system are constantly monitored and
the Warning LED flashes.
Warning LED (WARNING)
goes out (not lit)
Warning LED (WARNING)
lights
When the motor is rotating controlled by a seizing signal, this LED lights.
Rotating LED (RUN)
goes out (not lit)
Rotating LED (RUN)
lights
Normal
A problem has occurred.
Emergency stop of the motor spindle has occurred.
The Error code is displayed on the Digital Speed
Indicator ⑬ . (Refer to P94 " 17 - 3 Resetting
System after Error Codes Table. 9 ")
Normal
A problem has occurred.
The Warning code is displayed on the Digital Speed
Indicator ⑬ . (Refer to P93 " 17 - 1 WARNING
FUNCTION Table. 8 ")
The motor spindle has stopped.
The motor spindle is controlled by a seizing signal.