Break In Procedure - Nakanishi E2280 Operation Manual

⑭ Checking the Error History
Procedure
1. Push the START / STOP Button (START / STOP) ⑯ .
2. Alternately displayed are Error History
3. Push the Motor Speed Adjustment Button (SPEED
4. Alternately displayed are Error History
5. Push the Motor Speed Adjustment Button (SPEED
6. Alternately displayed are Error History
7. Push the Motor Speed Adjustment Button (SPEED
8. Alternately displayed are Error History
9. Push the Motor Speed Adjustment Button (SPEED
10. Alternately displayed are Error History
11. You can cycle through the choices by pushing the Motor Speed Adjustment Button (SPEED
12. Push the Error Reset Button (RESET) ㉑ while
13. If you desire to set other parameters, push the Motor Speed Adjustment Button (SPEED
select the parameter that needs to be set.
14. When you are finished setting parameters, turn the Main Power Switch ⑨ OFF.
Clearing the Error History
1. Push and hold the START / STOP Button (START / STOP) ⑯ for 3 seconds.
2. A beep emits and the Error History will be cleared.
3. Push the Error Reset Button (RESET) ㉑ .
4. If you desire to set other parameters, push the Motor Speed Adjustment Button (SPEED
5. When you are finished setting parameters, turn the Main Power Switch ⑨ OFF.
⑮
Confirmation of Software Version
Procedure
1. Push the START / STOP Button (START / STOP) ⑯ and the program version number will be displayed.
2. When you finished confirming, push the Error Reset Button (RESET) ㉑ and
3. If you desire to set other parameters, push the Motor Speed Adjustment Button (SPEED
select the parameter that needs to be set.
4. When you are finished setting parameters, turn the Main Power Switch ⑨ OFF.

19. BREAK IN PROCEDURE

During transportation, storage or installation the grease inside the bearings will settle. If the spindle is suddenly run at
high - speed, the lack of evenly distributed grease will cause excessive heat leading to bearing damage.
After installation, repair, initial operation, or long periods of non operation please follow the break - in procedure.
Please refer to the " BREAK IN PROCEDURE " in Operation Manual of the Motor / Spindle.
110
and the Error Code.
, ) ⑮ .
and the Error Code.
) ⑮ .
,
and the Error Code.
, ) ⑮ .
and the Error Code.
) ⑮ .
,
and the Error Code.
is displayed.
will be displayed.
, ) ⑮ .
) ⑮ to
,
) ⑮ .
,
will be displayed.
) ⑮ to
,