Siemens Sinamics S120 Comissioning Manual page 39

Subdivision of the "Properties" area
For each information type, there are additional subareas that can be displayed via secondary
tabs
The most important information type for SINAMICS S120 drives is the "Properties" area. The
following secondary tabs are displayed in this area:
● General
Display of the properties and settings of the drive device or the module. Here you can
enter the settings on the user interface. The secondary navigation is located in the left-
hand part of the inspector window. Information and parameters are arranged there in the
groups. When you click on the arrow icon at the left next to the group names, if
subgroups exist then you can open the group. If you select a group or a subgroup, then
the appropriate information and parameters are displayed in the right-hand part of the
inspector window, where they can also be edited.
For S120 drives, mainly the drive objects used are specified (e.g. an infeed unit) using
this subarea.
● I/O variables
Displaying I/O variables of the PLC. You can assign names to the variables, assign the
variables user-defined variable tables from a drop-down list - and allocate comments to
variables. The I/O variables are also listed in the PLC variable table.
● System constants
Display of the constants required by the system using the hardware identifiers of the
modules. The system constants are also listed in the PLC variable table.
● Texts
Display of the reference language and the specification of the text source for project
texts.
Commissioning with Startdrive
Commissioning Manual, (IH3), 07/2016, 6SL3097-4AA10-0BP0
②
.
Startdrive commissioning tool
2.3 User interface - parameterization
39