Startdrive Commissioning Tool; Overview - Siemens Sinamics S120 Comissioning Manual

With startdrive
Hide thumbs Also See for Sinamics S120:
Table of Contents

Advertisement

Startdrive commissioning tool

2.1

Overview

The Startdrive integrated engineering tool is available for the configuration and parameter
assignment of drives in the TIA Portal.
You can perform the following tasks, for example, with Startdrive:
● You create projects for drive-specific solutions.
● You insert drives in the project as single drives or link the drives to higher-level
controllers.
● You configure drives by entering the power units, motors and encoders used.
● You assign parameters to the drives by specifying command sources, setpoint sources
and control type.
● You extend the parameter assignment with drive-specific functions such as the free
function blocks and a technology controller.
● You go online on the drive and test the parameter assignment via the drive control panel.
● You perform diagnostics when an error occurs.
User interface
Startdrive is integrated seamlessly in the TIA Portal. The graphic user interface provides
support during the configuration and parameter assignment:
● In the hardware configuration, you select the drive, infeed, Motor Modules, motors and
sensors.
● Use the "Parameterization editor" to optimally adapt the drive according to the drive task.
● Insert specific components, such as Power Modules, in the "Device configuration".
● In the "Network view", network the drive with a higher-level controller and assign
parameters for the communication.
● In online mode, test the drive with the drive control panel and load the parameter
assignment to the drive.
Commissioning with Startdrive
Commissioning Manual, (IH3), 07/2016, 6SL3097-4AA10-0BP0
2
27

Advertisement

Table of Contents
loading

Table of Contents