Starting The N-Link Software And Setting The System Size; Sections Tab - jablotron JA-10 Series Manual

3. Getting the Activation Code from your distributor. When asking for the Activation Code you will need
to provide the registration code of the control panel. Depending on country, the activation code can
be also found on the package box of the control panel.

10.1 Starting the N-Link software and setting the system size

1. Connect a computer to the control panel using a USB cable – the computer will initialize the new USB device
(it may take a longer time if the control panel is being connected for the first time).
2. After the connection your computer will display two newly found drives: FLEXI_CFG
and FLEXI_LOG. If displayed, you can close the window.
3. Start the N-Link software. First start with "Virgin" control panel can take few minutes. If the control panel has
default settings, the Settings window will open and the system will automatically get into the Service mode. If
the control panel has been configured before (its service code has been changed), the software will request
entry of the code – it should be entered in the format nnnn (the default setting of the service code is 1010).
You can use the Remember option to make the software save the code until closing of the database. Use
the Display Code option to check the entered code e.g. if you use an alphanumerical keyboard where a
mistake can be made. Note: After establishing connection using the USB cable the possibility of
programming changes of settings from the LCD keypad will be disabled (menu item Settings will be
disabled). After disconnection of the cable the item will re-appear in the menu in a few seconds.
4. After proper authorization the following window can appear:
In such a case we recommend performing the update. After confirmation of the key the new firmware
package will be downloaded, which may take a few minutes.

10.2 Sections tab

Used to configure parameters of independently controlled monitored sections (zones). To make changes
in this tab you do not need to be in the Service mode.
JA-14K(R) Security System Control Panel
Example of sending a request using an SMS
42 / 72 MNX22101