Lan Settings - jablotron JA-10 Series Manual

No code for voice menu and control SMS – When the user accesses the system, it is not required to enter
the code (authorized by its own telephone number). It is necessary to have the caller ID service (CLIP)
activated.
Credit enquiry – by pressing this button you can immediately get information about the credit balance from the
operator's SMS reply (if this function is supported).
Credit - limit – possibility to set the lower limit for automatic checking of the limit of a pre-paid SIM card.
If the established credit is below this limit, the system will send and information SMS to the person whom
the reports SMS Errors and Service are assigned to. Caution: you are not recommended to use a pre-paid
card in the system – they increase the risk of a communication failure.
SIM credit sequence – command for automatic checking of the credit balance of a pre-paid SIM card
(if supported by the operator). You can obtain the command from your operator.
Credit - position in text – position (sequential number of the character) in the operator's credit balance report
at which the numerical information about the credit balance starts (the communicator only looks for numerals
in the report and ignores the other characters)
Credit - checking period – setting how often the system will check the credit balance (you can set 0 to 99 days
where 0 is off).
SIMLock – function that links the phone number of the SIM card to the ARC settings. It means that if you
replace the SIM card with another one and the SIM will be logged in to the GSM network, all the settings of the
ARC tab will be deleted. The deletion is irreversible and other settings (registration to the MyJABLOTRON web
service) must be performed by the ARC technician once again.
Sensitivity of DTMF detection from ARC – setting the sensitivity of reception of the signal generated by the
ARC. The sensitivity is adjustable in 10 steps; the optimum default value is 4.
Level of generated DTMF to the ARC – setting the intensity of the transmitted tone dialling signal in DTMF
generated by the control panel. The intensity is adjustable in 10 steps; the optimum default value is 4.
Number of incoming call rings – number of ringing impulses until automatic answering by the communicator.
You can set answering after 1 to 10 ringing impulses (corresponding to 5 to 50 seconds). The default value is 3
(15 seconds).
SIM card telephone number – Here the telephone number of the inserted SIM card is shown, the system
obtains it from the server.
Get telephone number of communicator – Button serves for getting the telephone number from server
manualy.

10.10.2 LAN Settings

It is used to set the LAN communicator.
LAN communicator – possibility to enable or disable LAN communication.
Get IP address from the DHCP server - automatic setting of network parameters. If this function
is not supported by the network, the respective parameters must be entered manually. Manual entry is only
possible if this option is deselected.
IP address – setting for manual IP address assignment that is only available if automatic assignment from
the DHCP server is not enabled. The default setting is 192.168.1.99
Subnet mask – setting for manual subnet mask IP assignment that is only available if automatic assignment
from the DHCP server is not enabled. The default setting is 255.255.255.0
Gateway – setting for manual default gateway IP assignment that is only available if automatic assignment from
the DHCP server is not enabled. The default setting is 192.168.1.1
JA-14K(R) Security System Control Panel 56 / 72 MNX22101