Diagnostics Tab; Calendars Tab - jablotron JA-10 Series Manual

Authorization type
Supervision of wireless
devices

10.8 Diagnostics tab

It is used to check and verify the status of devices and their properties.
Activation memory – registers activations of the device that have occurred since the last deletion of this
column. The memory of all devices activations can be deleted with the Delete memory button (bottom bar).
You can delete the memory of a selected device using the right mouse button. Activation of a tamper sensor
(TMP) has the highest priority when events are recorded in the memory.
Status – indicates the current status of the device. OK = everything all right, TMP = tampering, ACT = alarm
input activated, ERR = error, ?? = no communication with the device, Mains supply = supply failure
(or completely discharged battery), Charging – charging the backup battery in the device or control panel.
Battery = discharged or disconnected battery in the control panel, BOOT – upgrading of the device is going
on or upgrade failure (repeat upgrade). By moving the mouse cursor on the STATUS of the respective device
you will display details.
Battery status/voltage – If the device contains a battery, its status is displayed. For the control panel (position
0) the voltage of the backup battery is displayed. If the voltage data of a wireless device are missing, the device
has not communicated yet – activating its transmission (e.g. by means of the tamper sensor or
in N-Link click on the Refresh button) or wait until automatic transmission occurs. If wireless keypads are
powered by an external power supply source "Powered from external source" is indicated. Colour coding of the
battery status: 10% red, 20% yellow, 30% and higher green.
Voltage/loss – On the position of the control panel (0) voltage of the control panel terminals and current that
is drawn by the BUS devices from the control panel are displayed. For BUS device the line voltage loss as
compared to the control panel is displayed. The loss must not be higher than 2 V; otherwise the problem must
be solved.
RF signal level – indicates the quality of the signal with which the control panel communicates via GSM when a
supplementary GSM communicator connected or wireless device RF. The value should be at least 50%. If the
indication is missing, the device has not communicated yet – activated its transmission (e.g. by means of the
tamper sensor) or wait until automatic transmission occurs. The value on the control panel line is the strength of
the GSM network signal (about the interference between radio modules and the GSM module see also chapter
6.1 Installation of a JA-111R radio module).
Colour coding of the GSM signal: 0-30% red, 40-50% yellow and over 50% green.
Colour coding of the RF signal: 10% red, 20% yellow, 30% and higher green.
Channel – informs about the BUS used by the device to communicate. Two directions are distinguished: BUS
output and the RJ connector designed for the JA-111R radio module. There is a special column called Channel
which displays via which bidirectional devices communication currently occurs.

10.9 Calendars tab

Here, you can set the time schedule of events that the system will carry out automatically and regularly.
To make changes in this tab you do not need to be in the Service mode.
JA-14K(R) Security System Control Panel
Selection of the way the system processes user authorization. Related to
controlling a PG output with authorization.
Standard
Double authorization
Allows you to disable checking of regular communication with wireless devices
By the default, supervising of wireless devices (except remote controls) is
enabled.
52 / 72
Entering a user code, using an RFID tag will
accomplish valid authorization.
of these options is necessary to control the system.
Entering a user code and using an RFID tag will
accomplish valid authorization (regardless of the
order of authorization). N-Link monitors whether
a code and a tag are assigned to a user in the
Users tab (otherwise N-Link won't allow you to save
the configuration). Remote
is enabled for authorized numbers only.
Just one
phone access
MNX22101