Replacing A Controller; Replacing A Controller (For Dorado5000 V3) - Huawei OceanStor Dorado V3 Series Parts Replacement

OceanStor Dorado V3 Series
Parts Replacement
Figure 5-32 Indicators on a disk module
1
Step 8 Confirm the replacement.
1.
2.
3.
----End
Follow-up Procedure
After the disk module is replaced, label it to facilitate subsequent operations.

5.5 Replacing a Controller

This section describes how to replace a controller.

5.5.1 Replacing a Controller (for Dorado5000 V3)

This section describes how to replace a controller.
Issue 05 (2019-01-30)
Running indicator of
the disk module
Perform a post-replacement inspection.
After the parts replacement, return to the SmartKit page and click Replaced. Then
complete the check after the replacement as prompted.
Check system status.
On the Parts Replacement page, click Inspection to check the system status again. If
any inspection item fails, rectify the fault based on the suggestions in the inspection
report.
After the preceding procedure is complete, check services on the host for any storage-
related error.
Copyright © Huawei Technologies Co., Ltd.
2
5 Replacing FRUs
Alarm/Location
indicator of the disk
module
104