Advertisement
Locate temperature probe through pot wall.
7 7 ) )
Place gauge against pot wall as shows in
8 8 ) )
page
Push temperature probe through until it makes contact with gauge.
9 9 ) )
Tighten temperature probe in place.
1 1 0 0 ) )
Connect new temperature probe to the connector and fasten connector onto
1 1 1 1 ) )
control panel.
Replace control panel and reconnect power to vat.
1 1 2 2 ) )
Fill vat by pressing and holding the filter button until "*FILTER MENU*" shows in
1 1 3 3 ) )
the display. Then once "1.EXPRESS FILTER" shows in the display, press the
right arrow four times until "5.FILL FROM PAN" shows in the display. Press ✓
44
44.
Figure 6-1 Probe Assembly Install
E E x x c c e e s s s s f f o o r r c c e e w w i i l l l l d d a a m m a a g g e e t t e e m m p p e e r r a a t t u u r r e e p p r r o o b b e e . . H H a a n n d d - -
t t i i g g h h t t e e n n n n u u t t a a n n d d t t h h e e n n 1 1 / / 2 2 t t u u r r n n w w i i t t h h a a w w r r e e n n c c h h . .
Figure 6-1 Probe Assembly Install ,
Advertisement
