Advertisement
C C h h a a p p t t e e r r 4 4 P P r r o o d d u u c c t t P P r r o o g g r r a a m m
M M o o d d e e
This mode allows you to program the following:
• Change Product Name
• Assign Button
• Change Times & Temp
• Change Cook ID
• Alarms
• Quality Timers
• Include In Filter Count (Global)
• Filter After "X" Number Of Loads (Mixed)
• Load Compensation
• Load Compensation Reference
• Full Heat
• PC Factor
4 4 . . 1 1 M M o o d d i i f f y y i i n n g g P P r r o o d d u u c c t t S S e e t t t t i i n n g g s s
Press and hold the program button until "PROG" shows in the display, followed
1 1 ) )
by "ENTER CODE".
Enter code 1, 2, 3 (first 3 product buttons). "PRODUCT" and "PROGRAM" show
2 2 ) )
in the displays, followed by "SELECT PRODUCT" and "-P 1-" (ex: NUG).
C C h h a a n n g g e e P P r r o o d d u u c c t t N N a a m m e e s s
Use the up or down arrow to scroll through the 40 products, or press the desired
3 3 ) )
product button.
Press the right arrow and "NAME" shows in the left display and the product (ex:
4 4 ) )
NUGGETS) shows in the right display.
Press ✓ and the first letter in the name flashes. Press a product button and the
5 5 ) )
flashing letter changes to the first letter under the product button that was
pressed. For example, if product one is pressed, the flashing letter changes to
an "A".
Press the same button again and the flashing letter changes to a "B". Press it
6 6 ) )
again and flashing letter changes to a "C". Once the desired letter shows in
display, press the right arrow to continue to next letter and repeat the procedure.
Press and hold the right X X to exit Program Mode, or press the right arrow to
7 7 ) )
continue on to "COOK TIME".
15
Advertisement
