Advertisement
5 5 . . 1 1 . . 2 2 4 4 S S P P - - 2 2 4 4 S S e e r r i i a a l l N N u u m m b b e e r r L L o o g g
Press and release the right arrow until "SP-24 S/N ✓EDIT" flashes in the
1 1 ) )
displays, along with the serial number of the unit.
NOTE: This serial number should match the serial number on the data plate, on the
doors. If not, it can be recorded.
5 5 . . 1 1 . . 2 2 5 5 S S P P - - 2 2 5 5 P P r r o o g g r r a a m m C C o o d d e e C C h h a a n n g g e e
This allows the operator to change the program code (factory set at 1, 2, 3) used to
access Product Programming and Level 2 Program Mode.
Press and release the right arrow until "SP-25 CHANGE MGR CODE? 1=YES"
1 1 ) )
flashes in the display.
Press product button 1 and "ENTER NEW CODE, P=DONE, I=QUIT" scrolls
2 2 ) )
through the display. Press the product buttons for new code.
If satisfied with the code, press the program button and "REPEAT NEW CODE,
3 3 ) )
P=DONE, I=QUIT" shows in display. Enter the same code you previously
entered.
If satisfied with code, press the program button and "CODE CHANGED*" shows
4 4 ) )
in display.
If not satisfied with code, press the info button and "*CANCEL*" shows in
5 5 ) )
display, then reverts back to "SP-25" "CHANGE MGR CODE? 1=YES". Now the
above steps can be repeated.
5 5 . . 1 1 . . 2 2 6 6 S S P P - - 2 2 6 6 U U s s a a g g e e C C o o d d e e C C h h a a n n g g e e
This allows the operator to change the reset usage code (factory set at 1, 2, 3) to reset
the usage amounts of each product. See
Mode.
Press and release the right arrow until "SP-26 CHANGE USAGE CODE? 1=
1 1 ) )
YES" flashes in the display.
Press product button 1 and "ENTER NEW CODE, P=DONE, I-QUIT" scrolls
2 2 ) )
through display. Press product buttons for new code.
If satisfied with code, press the program button and "REPEAT NEW CODE, P=
3 3 ) )
DONE, I=QUIT" shows in the display. Enter the previously entered code.
If satisfied with code, press the program button, "*CODE CHANGED*" shows in
4 4 ) )
display.
If not satisfied with code, press the info button and "*CANCEL*" shows in display
5 5 ) )
the reverts back to "SP-26" "CHANGE USAGE CODE? 1=YES". Now the above
steps can be repeated.
5 5 . . 1 1 . . 2 2 7 7 S S P P - - 2 2 7 7 D D i i s s p p o o s s e e R R e e q q u u i i r r e e s s C C o o d d e e ? ?
Press and release the right arrow and "SP-27 DISPOSE REQUIRES CODE?"
1 1 ) )
flashes in the left display.
Press the up or down arrow to choose "YES" or "NO". If set to "YES", code 1, 2,
2 2 ) )
3, must be entered to discard the oil from the vat using the Dispose Mode.
3.1.5 Review Usage , page 12
in Information
27
Advertisement
