Advertisement
Remove the clamp bars.
6 6 ) )
Using a 5/16 inch wrench remove the two nuts on the high limit bracket, and
7 7 ) )
then slide the high limit control off of mounting studs.
Install the new control in reverse order.
8 8 ) )
6 6 . . 6 6 M M a a i i n n P P o o w w e e r r S S w w i i t t c c h h
Lower the control board (refer to
1 1 ) )
page
Press on the switch from the inside of the fryer to release from the metal shroud.
2 2 ) )
Mark and disconnect the wires from the switch.
3 3 ) )
Connect the wires onto the new switch on the correct terminals.
4 4 ) )
Press back into factory location.
5 5 ) )
40
T T o o a a v v o o i i d d e e l l e e c c t t r r i i c c a a l l s s h h o o c c k k o o r r p p r r o o p p e e r r t t y y d d a a m m a a g g e e , , m m o o v v e e t t h h e e
p p o o w w e e r r s s w w i i t t c c h h t t o o o o f f f f a a n n d d d d i i s s c c o o n n n n e e c c t t m m a a i i n n c c i i r r c c u u i i t t b b r r e e a a k k e e r r , , o o r r
u u n n p p l l u u g g c c o o r r d d a a t t w w a a l l l l r r e e c c e e p p t t a a c c l l e e . .
38).
6.4 Control Panel & Menu Card Replacement ,
Advertisement
