Keysight M9614A Startup Manual page 14

Step 4: Install the Module
Before the module installation, make sure that the controller is turned off.
Procedure 1. Make sure that the power cord is plugged into a grounded outlet to establish
2. Make sure that the chassis power switch is off.
3. If the chassis has multiple fan speed settings, ensure that the fans are set to
4. Remove the filler panel that covers the slot in which you want to install the
5. Remove thread protectors from the top and bottom mounting screws of the
6. Hold the module by the injector/ejector handle, and slide it into the slot.
7. Latch the module by pulling up on the injector/ejector handle and secure the
8. Tighten the screws on the module front panel. Performance may suffer if the
9. Install all chassis covers, filler panels, and air scoops after installing the
For more information on the module installation, refer to the PXIe chassis
documentation.
Ensure that filler panels are installed in all empty slots. Missing filler panels will
impact cooling of the chassis and may cause RFI (radio frequency interference)
with other devices.
14
earth ground and to prevent ESD.
automatic. Do not set the fan speed to low or turn them off.
module.
module.
Install the module into the slot of the chassis by placing the module card
•
edges into the front module guides (top and bottom).
Slide the module to the rear of the chassis and assure that the injector/
•
ejector handle is pushed down in the unlatched (downward) position.
Slide the module completely into the chassis. When you begin to feel
•
resistance, push up on the injector/ejector handle to fully seat the module
into the chassis.
front panel to the chassis using the module front-panel mounting screws.
screws are not securely tightened.
module. Also see CAUTION below.
Keysight M9614A/M9615A Startup Guide, Edition 1