Keysight M9614A Startup Manual page 3

- If an instrument is marked CAT I (IEC Mea-
surement Category I), or it is not marked with
a measurement category, its measurement
terminals must not be connected to line-volt-
age mains.
- System installation, safety and performance
are the responsibility of the assembler of the
system.
WAR NI NG
The persons who plan, supervise, consign, and
implement the installation, start-up, mainte-
nance, and delivery of this product are
required to carefully read documents related
to the equipment and take and implement
safety measures to prevent accidents. Also,
safety and performance of the system in which
the equipment is installed are the responsibil-
ity of the assembler responsible for the system
construction.
WAR NI NG
Equipment built in the system may be heavy.
So there is the possibility of physical disability
in the person by moving the equipment to a
high place or moving it from a high place. To
prevent accidents, take appropriate safety
work means.
DANGEROUS PROCEDURE WARNINGS
Warnings, such as above WARNING, shall be
complied. Procedures throughout in this man-
ual prevent you from potentially hazard. Their
instructions contained in the warnings must
be followed.
BEFORE APPLYING POWER
Verify that all safety precautions are taken.
Make all connections to the instrument before
applying power. Note the instrument's exter-
nal markings described under "Safety Sym-
bols".
GROUND THE INSTRUMENT
This is Safety Class I instrument. To minimize
shock hazard, the instrument chassis and cab-
inet must be connected to an electrical
ground. The power terminal and the power
cable must meet International Electrotechni-
cal Commission (IEC) safety standards.
DO NOT OPERATE IN AN EXPLOSIVE
ATMOSPHERE
Do not operate the instrument in the presence
of flammable gases or fumes. Operation of any
electrical instrument in such an environment
constitutes a definite safety hazard.
DO NOT REMOVE COVERS
No operator serviceable parts inside. Refer
servicing to qualified personnel. To prevent
electrical shock do not remove covers.
IN CASE OF DAMAGE
Instruments that appear damaged or defective
should be made inoperative and secured
against unintended operation until they can be
repaired by qualified service personnel.
Return the instrument to a Keysight Technolo-
gies sales or service office for services and
repair to ensure that safety features are main-
tained.
USE ONLY THE SPECIFIC ACCESSORIES
Specific accessories satisfy the requirements
for specific characteristics for using the
instrument. Use the specific accessories,
cables, adapters, and so on for safety reasons.
Safety Symbols
The general definitions of safety symbols used
on equipment or in manuals are listed below.
Direct current.
Alternating current.
Earth ground terminal.
Protective conductor terminal. For
protection against electrical shock
in case of a fault. Used with field
wiring terminals to indicate the ter-
minal which must be connected to
ground before operating equip-
ment.
Frame or chassis terminal. A con-
nection to the frame (chassis) of the
equipment which normally includes
all exposed metal structures.
Grounded terminal which indicates
the earth potential.
On supply.
Off supply.
Standby supply. The equipment will
be marked with this symbol is not
completely disconnected from AC
mains when power switch is in the
standby position.
In position of a bi-stable push
switch.
Out position of a bi-stable push
switch.
Hazardous voltage and potential for
electrical shock. Do not touch ter-
minals that have this symbol when
the equipment is on.
Hot surface. Avoid contact. Sur-
faces are hot and may cause per-
sonal injury if touched.
Low temperature or freezing condi-
tions. Avoid contact. Surfaces are
cold and may cause personal injury
if touched.
Heavy object. Lifting can cause
back injury. Use mechanical lifting
device to move.