Step 4: Install The Module - Keysight M9614A Startup Manual

Step 4: Install the Module

Current capacity of the PXIe chassis may restrict the module configuration. For
more information, refer to the M9614A/M9615A data sheet and the PXIe chassis
documentation.
PXIe hardware does not support "hot-swap" (changing modules while power is
applied to the chassis) capabilities. Before installing or removing a module
to/from the chassis, power down the chassis to prevent damage to the module.
Place the chassis on a static-safe work station (see
(ESD) Precautions" on page
between the chassis fan intake and exhaust vents. Blockage by walls or
obstructions affects the air flow needed for cooling.
For more information about precautions and cooling, refer to the PXIe chassis
documentation.
Generic module installation is shown below. It may not reflect your module's
actual size and chassis placement. Install the leftmost module first and continue
installing modules from left to right according to the image below.
Keysight M9614A/M9615A Startup Guide, Edition 1
8). And position it so that there is ample space
Step 4: Install the Module
"Electrostatic Discharge
13