Playing Back A Clip; Deleting Clips - AJA KiProRack Installation And Operation Manual

Playing Back a Clip

Deleting Clips

Ki Pro Rack Installation and Operation Manual — TRANSPORT Mode (default)
To playback recorded media, you simply select the clip desired and press PLAY. If the
clip you wish to playback is not currently selected, use the SELECT up/down buttons
until the clip name appears on the display. Like recording, there is more than one way
to initiate playback (front panel, web browser). From the front panel these are the basic
steps:
1. Press the STOP button to get to the TRANSPORT mode (if not already there). Find
the clip name in the display (it shows the current clip/reel).
2. Press the SELECT up or down arrow button repeatedly until you find the clip you
are looking for.
3. Press the PLAY button (>).
4. When playing back a clip (PLAY, FF, or REV) the first push of STOP acts as a "Pause"
mode: the playback is paused, the current point of the clip is displayed, and the
STOP button will flash. A second push of STOP will completely stop the playback
and Ki Pro's outputs will go into an "E to E" mode (the currently selected inputs
will be bypassed to the outputs). When a playback reaches the end of a clip, it will
automatically pause on the last frame of the clip.
During playback you can use the FFWD, REV, SELECT, or ADJUST buttons as follows:
FFWD >>: Press button to begin fast playback of the current clip at 2x speed.
Successive pushes increase the speed to 4x, 8x, and 16x. (Pushing the button
after 16x speed is reached has no further effect.) When fast-forwarding, audio is
muted.
REV <<: Pressing REV when not lit, begins playback of the current clip in reverse
at 1x speed. Successive pushes increase the speed to 2x, 4x, 8x, and 16x. (Pushing
the button after 16x speed is reached has no further effect.) When playing in
reverse, audio is muted for all speeds.
SELECT (up/down): while in TRANSPORT mode, the SELECT buttons select clips
and operate like "previous" and "next" keys. When a clip is selected it is "cued" to
the beginning of the clip. Note that ordering and playback of clips is based on
timestamp order, not clip name. If you have paused playback (the STOP button is
flashing), you can use the SELECT down button to jump back to the beginning of
the clip. If the STOP button is not flashing, depressing the SELECT down button
will select the previous clip.
ADJUST (up/down): while in TRANSPORT mode, and in either a "STOP" or
"pause" state, the ADJUST buttons will "single step" the current clip at a rate of
one frame per button push (up=forward, down=reverse).
To delete a previously recorded clip:
1. In TRANSPORT mode, use the SELECT up and down arrow buttons to browse
through the clips on the current storage device.
2. When you find a clip you want to delete, press the DELETE CLIP button.
3. Ki Pro will ask "Are you sure"—press the ADJUST up arrow button to confirm
deletion. Pressing the down arrow, or any other button, will abort the deletion.
39
1