Checking The Tamper Foot - Fayat BOMAG BT 60 Operating And Maintenance Instructions Manual

Maintenance

6.7.3 Checking the tamper foot

Checking the oil level
Fig. 43
54
Turn the spark plug carefully in by hand.
Once the sealing surface of the new spark plug is in contact
tighten for another 1/2 turn with the spark plug spanner.
Once the sealing surface of the used spark plug is in contact
tighten for another 1/8 to 1/4 turn with the spark plug
spanner.
Press the spark plug socket back on.
WARNING!
Danger of burning on hot components!
Wear your personal protective outfit (protective gloves,
protective clothing).
NOTICE!
Stand the tamper of level ground for a short while, so
that all oil can run into the housing.
For quality of oil refer to the "table of fuels and lubri-
cants".
Clean the sight glass Ä Fig. 43.
Check the oil level.
The oil must be visible between the middle and the upper
edge of the oil level inspection glass, if necessary top up oil
as required.
The upper edge of the inspection glass equals the
bottom edge of the oil filling.
BT 60 / BT 65