Fayat BOMAG BT 60 Operating And Maintenance Instructions Manual page 58

Fig. 55
Fig. 56
Mount the recoil starter to the
engine housing:
Fig. 57
Apply a bead of liquid gasket (Three Bond 1207B or similar)
with a diameter of approx. 1.5 to 2.0 mm (0.06 to 0.08 in) to
the inside of the cylinder head cover Ä Fig. 55.
Attach the cylinder head cover within the next 10
minutes.
Place the cylinder head cover on the cylinder block and
tighten the fastening screws.
NOTICE!
Do not mix up the fastening screws for the recoil
starter by mistake!
Attach the screw M6x12 (1) Ä Fig. 56 with washer (2) and
clamp (3) to the recoil starter.
Attach the screw M6x16 (6) with washer (5) and bracket for
engine guard plate to the recoil starter.
Attach the screw M6x8 (4) to the recoil starter.
Tighten screws (1), (4) and (6).
Reattach the steering bow with the tank.
Tighten the screws (1) Ä Fig. 57 (right hand side) of the air
filter housing hand-tight (max. tightening torque 50 Nm (37
ft.lbs.).
BT 60 / BT 65
Maintenance
59