Changing The Tamper Foot Plate - Fayat BOMAG BT 60 Operating And Maintenance Instructions Manual

Operation

5.7 Changing the tamper foot plate

Fig. 28
Fig. 29
Fig. 30
38
WARNING!
Danger of burning on hot components!
Wear your personal protective outfit (protective gloves,
protective clothing).
Always shut the engine down before laying the tamper on its
side.
Lay the tamper on its side Ä Fig. 28.
Unscrew 4 fastening screws Ä Fig. 29.
Take off the tamper foot plate and lay the tamper foot on the
floor.
Fasten the new tamper foot plate with 4 fastening screws
(tightening torque 60 to 70 Nm (44 bis 52 ft.lbs)) to the
tamper foot Ä Fig. 30.
When changing the tamper foot to a different width use
only genuine BOMAG parts.
After changing the tamper foot check the engine speed,
adjust it if necessary.
BT 60 / BT 65